A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element.

The current through a resistor is in direct proportion to the voltage across the resistor's terminals. This relationship is represented by Ohm's law:

where I is the current through the conductor in units of amperes, V is the potential difference measured across the conductor in units of volts, and R is the resistance of the conductor in units of ohms.

The ratio of the voltage applied across a resistor's terminals to the intensity of current in the circuit is called its resistance, and this can be assumed to be a constant (independent of the voltage) for ordinary resistors working within their ratings.

Resistors are common elements of electrical networks and electronic circuits and are ubiquitous in electronic equipment. Practical resistors can be made of various compounds and films, as well as resistance wire (wire made of a high-resistivity alloy, such as nickel-chrome). Resistors are also implemented within integrated circuits, particularly analog devices, and can also be integrated into hybrid and printed circuits.

The electrical functionality of a resistor is specified by its resistance: common commercial resistors are manufactured over a range of more than nine orders of magnitude. When specifying that resistance in an electronic design, the required precision of the resistance may require attention to the manufacturing tolerance of the chosen resistor, according to its specific application. The temperature coefficient of the resistance may also be of concern in some precision applications. Practical resistors are also specified as having a maximum power rating which must exceed the anticipated power dissipation of that resistor in a particular circuit: this is mainly of concern in power electronics applications. Resistors with higher power ratings are physically larger and may require heat sinks. In a high-voltage circuit, attention must sometimes be paid to the rated maximum working voltage of the resistor.

Practical resistors have a series inductance and a small parallel capacitance; these specifications can be important in high-frequency applications. In a low-noise amplifier or pre-amp, the noise characteristics of a resistor may be an issue. The unwanted inductance, excess noise, and temperature coefficient are mainly dependent on the technology used in manufacturing the resistor. They are not normally specified individually for a particular family of resistors manufactured using a particular technology. A family of discrete resistors is also characterized according to its form factor, that is, the size of the device and the position of its leads (or terminals) which is relevant in the practical manufacturing of circuits using them.

Read more about Resistor:  Units, Electronic Symbols and Notation, Measurement, Resistor Marking, Electrical and Thermal Noise, Failure Modes

Other articles related to "resistor, resistors":

Test Probe - Current Probes - Sampling Resistor
... The classic current probe is a low valued resistor (a "sampling resistor" or "current shunt") inserted in the current's path ... by measuring the voltage drop across the resistor and using Ohm's law ...
Shift Resistor
... Shift resistor may mean CMOS digital level shifter Pull-up resistor. ...
Cathode Bias - Uses
... In a more simple circuit, which has less than unity gain, the cathode and plate resistors are made equal ... In accordance with Kirchhoff's law, the current through both resistors will be equal, thus the voltage across them will also be equal ... a pair of amplifier tubes with a common cathode resistor ...
Resistor - Failure Modes
... The failure rate of resistors in a properly designed circuit is low compared to other electronic components such as semiconductors and electrolytic ... Damage to resistors most often occurs due to overheating when the average power delivered to it (as computed above) greatly exceeds its ability to dissipate heat (specified ... component (such as a transistor that shorts out) in the circuit connected to the resistor ...
Starling Resistor
... The Starling resistor was invented by English physiologist Ernest Starling and used in an isolated-heart preparation during work which would later lead to the "Frank–St ... of collapse of the tube, so providing a variable resistor ... Starling resistors have been used both as an instrument in the study of interesting physiological phenomena (e.g ...