First Online Computer Control
Online computer control of steel making processes became a reality with the first use of computers on a hot strip mill in 1962. McLouth Steel used a General Electric 312 computer for gauge control on the finishing train of a semi-continuous mill. The aim was to set up the initial roll gap and then establish correct gauge as soon as the head end of the strip emerged onto the runout table. The finishing train started running under continuous computer control on November 1, 1962.
"Probably the most exciting application of the GE 312 was to the hot strip mill of McLouth Steel Co. in Michigan. It was a difficult design inasmuch as each step in the process had to be varied on the basis of the measured values of the previous step. This required continuous high speed feedback to set the six different hot stands with absolute accuracy and reliability being essential; an error at one point could be magnified at the next, causing an entire process to go out of control. Fortunately, the GE 312 met the challenge." H. Oldfield, General Manager of the GE Computer Department.
The Solid State circuitry of a GE 312 computer was composed of 2500 diodes, 2500 transistors, and 12,000 resistors, but no magnetic core memory. There were 20 binary digits per word or per instruction. All arithmetic was fixed point. Numbers were 19 bits plus the associated positive or negative sign, not a very big number range when expressed in decimal form, just -524,287 to +524,287. The GE 312 was designed by A. Spielberg of the GE Computer Department that was newly formed in 1957.
Read more about this topic: Mc Louth Steel
Famous quotes containing the words computer and/or control:
“Family life is not a computer program that runs on its own; it needs continual input from everyone.”
—Neil Kurshan (20th century)
“If someone does something we disapprove of, we regard him as bad if we believe we can deter him from persisting in his conduct, but we regard him as mad if we believe we cannot. In either case, the crucial issue is our control of the other: the more we lose control over him, and the more he assumes control over himself, the more, in case of conflict, we are likely to consider him mad rather than just bad.”
—Thomas Szasz (b. 1920)