Dimmer

Dimmer

Dimmers are devices used to vary the brightness of a light. By decreasing or increasing the RMS voltage and, hence, the mean power to the lamp, it is possible to vary the intensity of the light output. Although variable-voltage devices are used for various purposes, the term dimmer is generally reserved for those intended to control light output from resistive incandescent, halogen, and (more recently) compact fluorescent lights (CFLs) and light-emitting diodes (LEDs). More specialized equipment is needed to dim fluorescent, mercury vapor, solid state and other arc lighting.

Dimmers range in size from small units the size of a light switch used for domestic lighting to high power units used in large theatre or architectural lighting installations. Small domestic dimmers are generally directly controlled, although remote control systems (such as X10) are available. Modern professional dimmers are generally controlled by a digital control system like DMX or DALI. In newer systems, these protocols are often used in conjunction with ethernet.

In the professional lighting industry, changes in intensity are called “fades” and can be “fade up” or “fade down”. Dimmers with direct manual control had a limit on the speed they could be varied at but this issue has been largely eliminated with modern digital units (although very fast changes in brightness may still be avoided for other reasons like lamp life).

Modern dimmers are built from silicon-controlled rectifiers (SCR) instead of variable resistors, because they have higher efficiency. A variable resistor would dissipate power as heat and acts as a voltage divider. Since a silicon controlled rectifier switches between a low resistance "on" state and a high resistance "off" state, it dissipates very little power compared with the controlled load.

Read more about Dimmer:  History, Control, Patching, Dimming Curves, Preheat, The Digital Revolution, Rise Time

Other articles related to "dimmer, dimmers":

Light Switch - Variations On Design - Dimmer Switch
... See also Dimmer A dimmer switch, properly called a dimmer control, contains a solid-state circuit to allow changing the brightness by reducing the average voltage applied to the lamp ...
Distributed Dimming - Reduced Wiring Cost By Shared Neutrals
... Because shared neutrals often cause problems when run upstream of dimmers, the idea of locating the dimmer as far downstream as possible reduces wiring costs by allowing shared ... form of (much copied) distributed dimming is the Rosco 6-dimmer bar that is supplied by a 3-phase 20-Amp circuit, usually connected to an L21-20 receptacle ... As a conservative measure, the 6-dimmer bar usually comes wired with 10-gauge (although 12 gauge would be enough for 20Amps) wire, having a common (shared) neutral, and three hot wires ...
John Henry Stephen Dimmer
... Lieutenant Colonel John Henry Stephen Dimmer VC MC (9 October 1883 – 21 March 1918) was an English recipient of the Victoria Cross, the highest and most prestigious award for gallantry in the face of the ... Born on 9 October 1883, Dimmer was 31 years old, married, and a lieutenant in the 2nd Battalion, The King's Royal Rifle Corps, and was awarded the VC for his actions on 12 November 1914 at Klein ...
Dimmer - Rise Time
... One measure of the quality of the dimmer is the "rise time" ... A longer rise time reduces the noise of the dimmer and the lamp as well as extending the life of the lamp ...
Shayne Carter - Musical History - Dimmer
... Following the demise of Straitjacket Fits, in 1995 Carter formed the group Dimmer ... Carter disbanded Dimmer in 2012 with a series of final concerts in Auckland and Wellington ...