Adjustments

Polar Mount - Description - Adjustments
... and longitude, means polar mounts need further adjustments to allow one axis slewing Declination angle - The declination angle or just "declination", from the astronomical term declination for ...

Single-Minute Exchange Of Die - Implementation - Key Elements To Observe
... Proportion of time Preparation, after-process adjustment, and checking of raw materials, blades, dies, jigs, gauges, etc ... Centering, dimensioning and setting of conditions 15% Trial runs and adjustments 50% Look for shortages, mistakes, inadequate verification of equipment causing delays and can be avoided by ... attachment points that take more than one turn to fasten any adjustments after initial setup any use of experts during setup any adjustments of assisting tools such as ...

Traverso - Construction and Materials
... It is possible to make fine adjustments to tuning by adjusting the headjoint cork, but usually it is left in the factory-recommended position around 17.3 mm from the centre of the embouchure hole ... Gross, temporary adjustments of pitch are made by moving the headjoint in and out of the headjoint tenon ... The player makes fine or rapid adjustments of pitch and timbre by adjusting the embouchure, and/or adjusting the position of the flute in relation to the player, i.e ...

C79 Optical Sight - Operation
... Two adjustment knobs are used to secure the base to the receiver ... Adjustments come in 0.25-mil clicks (one mil equals 10 cm at a range of 100 m, so each click adjusts the sight by 2.5 cm at 100 m) ... Windage adjustments are made on the left hand side of the base, using a flat object such as a flat-head screwdriver or a coin ...