Solar-powered Refrigerator - Rationale


There is environmental concern regarding conventional refrigeration technologies including contribution to ozone layer depletion and global warming. Refrigerators which contain ozone depleting and global warming substances such as chlorofluorocarbons (CFCs), in their insulation foam or their refrigerant cycle, are the most harmful. After CFCs were banned in the 1980s, they were replaced with substances such as hydrochlorofluorocarbons (HCFCs), which are ozone-depleting substances and hydrofluorocarbons (HFCs). Both are environmentally destructive as potential global warming chemicals. If a conventional refrigerator is inefficient or used inefficiently, it will also contribute more to global warming than a highly efficient refrigerator. The use of solar energy to power refrigeration strives to minimize the negative impacts refrigerators have on the environment. Fishermen in the village of Maruata, which is located on the Mexican Pacific coast 18 degrees north of the equator, have no electricity. But for the past 16 years they have been able to store their fish on ice: Seven ice makers, powered by nothing but the scorching sun, churn out a half ton of ice every day.

There's a global scramble to drive down emissions of carbon dioxide: the electricity to power just refrigerators in the U.S. contributes 102 million tons annually. Solar refrigeration can also be inexpensive and it would give the electric grid much-needed relief. Electricity demand peaks on hot summer days—150 gigawatts more in summer than winter in the U.S. (A gigawatt equals one billion watts.) That's almost 1.5 times the generating capacity of all the coal-fired power plants west of the Mississippi River. Further, solar is plentiful. The solar energy hitting 54 square feet (five square meters) of land each year is the equivalent of all the electricity used by one American household, according to data from the National Renewable Energy Laboratory and Energy Information Administration, both part of the U.S. Department of Energy.

Making cold out of hot is easier than one might think. A group of students last year at San Jose State University built a solar-powered ice maker with $100 worth of plumbing and a four-by-eight-foot (1.2-by-2.4-meter) sheet of reflecting steel. No moving parts, no electricity, but give it a couple hours of sunshine and it can make a large bag of ice.

The key is the energy exchanged when liquids turn to vapor and vice versa—the process that cools you when you sweat. By far the most common approach, the one used by the refrigerator in your house, uses an electric motor to compress a refrigerant—say, Freon—turning it into liquid. When the pressure created by the compressor is released, the liquid evaporates, absorbing heat and lowering the temperature.

Absorptive chillers like solar refrigerators use a heat source rather than a compressor to change the refrigerant from vapor to liquid. The two most common combinations are water mixed with either lithium bromide or ammonia. In each case, the refrigerating gas is absorbed until heat is applied, which raises the temperature and pressure. At higher pressure, the refrigerant condenses into liquid. Turning off the heat lowers the pressure, causing that liquid to evaporate back into a gas, thereby creating the cooling effect.

As with most technologies, the efficiency of such absorptive refrigeration depends on the degree of engineering (and expense) brought to bear. Single-effect devices have a coefficient of performance of 0.6 to 0.7—that is, they create 60 to 70 Btus (British thermal units) of cooling for every 100 Btus of input heat. That low level of efficiency can be achieved with something as crude as some pipe, a bucket of water, some calcium chloride (as absorbent), ammonia (as refrigerant), and a sheet of shiny metal (the solar collector).

If what one wants to do is heat or cool, using solar energy this way is probably more efficient—and certainly cheaper—than converting it first into electricity. "That approach ought to be comparable to photovoltaics, or a little better," said Tom Mancini, program manager for solar power at the Sandia National Laboratories in Albuquerque, N.M.

It would take a fair-size collector—86 square feet (eight square meters), assuming 40 percent panel efficiency—just to deliver the cooling of a small (6,000 Btu per hour or half-ton) window air conditioner. And central air-conditioning units are often 30,000 Btu or more; few homeowners could spare the space for that.

Read more about this topic:  Solar-powered Refrigerator