||Writes the 8-bit value "new" (in hex) to 16-bit address
||Dumps the values from addresses
||Sets the programme counter to the 16-bit address
|X (Examine)||X||Allows the user to display and change the contents of each register. The RETURN key applies the changed value (if any) and jumps between registers. Typing a non-hexadecimal character exits this command.|
||Transfer data from an external storage to memory.
||Transfer data from memory specified by the "A (Address)" command to an external storage. See "R (Read)" for more information. ROM cartridge is not supported by this command.|
||Verifies data transferred to an external storage against the memory specified by the "A (Address)" command. See "R (Read)" for more information. ROM cartridge is not supported by this command.|
|A (Address)||A||Specify an address range for commands R, W and V. The user will be prompted with T (Top address), L (Last address), O (Offset value) and E (Entrypoint). Offset and entrypoint values are only used by the "W (Write)" and "V (Verify)" commands.|
|K (Key set)||K
||Enter a sequence of keys to be pressed automatically on power up (and reset). Press CTRL+@ to stop. A maximum of 18 characters can be entered and function keys counts as two characters.|
|B (Back)||B||Return to the procedure from which Monitor was called.|
Other articles related to "commands, command":
... These tests were with a human controller giving voice commands to the robot to give it orders ... Giving voice commands is seen as a more efficient way of controlling the LS3, because a soldier would be too peoccupied with a joystick and computer screens to focus on a mission ... There are currently ten commands that the system can understand ...
... As such it was designed to offer the following commands Continue - Continue execution until CTRL-C or exit ... Type - List file on terminal It also included the following new commands (which at the time of design had no abbreviations) MEMORY - List amount of memory ...
... consistent with the SCSI architectural model, the SCSI Primary Commands, and the SCSI Block Commands standards ... The standard allows for translation of common SCSI Block Commands such as SCSI Read Commands SCSI Write Commands The standard also provides the ability to control exactly what ATA operations are ...
... The standard specifies a common syntax, command structure, and data formats, to be used with all instruments ... It introduced generic commands (such as CONFigure and MEASure), which could be used with any instrument ... These commands are grouped into subsystems ...
... For LabelTag no new commands are introduced, the changes are made to the already existing commands ... more image lines is sent to the drive via the WRITE12 SCSI Write Commands ... The WRITE12-command is called TAGWRITE-command to emphasis the dedicated LabelTag SCSI mode pages settings ...
Famous quotes containing the word commands:
“Those commands of superiors which are contrary to our first duties are not to be obeyed.”
—Samuel Richardson (16891761)
“It is clear that in a monarchy, where he who commands the exceution of the laws generally thinks himself above them, there is less need of virtue than in a popular government, where the person entrusted with the execution of the laws is sensible of his being subject to their direction.”
—Charles Louis de Secondat Montesquieu (16891755)
“There are no more ideologies in the authentic sense of false consciousness, only advertisements for the world through its duplication and the provocative lie which does not seek belief but commands silence.”
—Theodor W. Adorno (19031969)